Five positive spikes are applied at the 0 and 90-degree angles and then fie negative spikes are applied at the 0 and 270-degree angles. Look for devices with a clamping voltage of 400V or lower. Line-to-line and line-to-ground testing is applicable with synchronization to the line under test to ensure the spike is applied at the correct phase angles. The clamping voltage is the voltage at which the surge protector will be activated to protect your equipment. Look for surge protectors with an absorption rating of at least 600 joules. Without a surge protector, anything higher than. When a threshold is over 120V, a surge protector shorts to ground voltage or blocks the voltage. The absorption rating is how much power the surge protector can withstand in a surge. Surge Protector: A surge protector is an electrical device that is used to protect equipment against power surges and voltage spikes while blocking voltage over a safe threshold (approximately 120 V). When purchasing a surge protector, two important specs are the absorption rating and clamping voltage. For surge protectors, check absorption ratings and clamping voltage.It can be a good idea to purchase a device with more outlets than you need now so you’ll have some extra room to plug in any new devices you add to your setup. Of course, you want to buy a device with enough outlets to support the number of devices that you want to plug in. When purchasing either a UPS, surge protector, or power strip, one important consideration is the number of outlets. This helps the UPS to remain charged for immediate response and built-in surge protection adds that layer of defense that also comes standard with a surge protector. Plugging the UPS directly into the wall helps to ensure the most consistent power goes directly to the UPS and limits the times it will go to battery when it should remain online. Likewise, it is not generally advisable to plug your uninterrupted power source into a surge protector either. Don’t plug a UPS into a surge protector.Always use a wall socket instead to avoid drawing too much power from your UPS, resulting in an inefficient user experience and possibly triggering an overload. Don’t plug a surge protector into a UPS outlet.When using UPS and surge protectors for PCs and devices, especially when using them both at the same time, there are some important safety tips to keep in mind:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |